![]() I will keep trying to figure this out, perhaps the post is usable if I can fix this error. I tried the DNM-500 post supplied by the reseller and it faulted the controller during the run (on a G41 line) I will test them one a time and see if any work correctly. I will go through them and test one at a time, but am open to suggestions as to which of these controllers may be closest to the Fanuc Oi-MF. They have a few other Fanuc posts as well,Īre any of these posts worth trying? - just curious if anyone has an opinion or knowledge about this This is allowing me to use the machine until I get a better post configured (it puts G41 T3# on lines when it applies cutter comp, with the # being the actual tool number,Īnd I need to remove the 3 which is not too bad, not sure why it does this though) I have been able to post and run GCODE using a generic post called FANUCOM that comes with CAMWORKSīut I have to modify the code by hand to eliminate errors I am trying to locate or make a CAMWORKS 2019 post to run with a Doosan DNM-5700, with the Fanuc Oi-MF controller I am using Solidworks 2019 with Camworks 2019. ![]() ![]() I have a Doosan DNM-5700 but am still working on getting a good post to work with my CAD/CAM Setup. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |